AOpen DE7200 Series Instruções de Operação descarregar pdf (Página 73)

MAINTENANCE

31 Dec 13 5-11

DE-7200VFDCentrifuge

Cleaning Purge Unit Filter

Do not use solvents on any part of the filter assembly installed inside the purge unit. To

clean the filter element, unscrew and remove the filter bowl and then unscrew and

remove filter element. Clean filter element in soapy water or replace element.

ROTATING ASSEMBLY MAINTENANCE

Maintenance of the rotating assembly is limited to removal, cleaning, inspection, and replacement

of wear inserts. Excessive noise or vibration during centrifuge operation may indicate defective

main or conveyor bearings. If such conditions are evident, the bearings should be checked for

high temperature and excessive noise. The rotating assembly must be replaced if defective main

or conveyor bearings are found, or if internal damage to the rotating assembly is found or

suspected. The damaged rotating assembly should be returned to Derrick for overhaul.

Rotating Assembly Removal

To remove the rotating assembly, proceed as follows:

WARNING! TO AVOID SERIOUS PERSONAL INJURY BE SURE EQUIPMENT IS

LOCKED OUT, TAGGED OUT, DE

-ENERGIZED, AND HAS STOPPED

ROTATING BEFORE PERFORMING MAINTENANC

E AND/OR ADJUSTMENTS.

1. Turn off feed, shut down centrifuge, and lock out and tag out electric power to the centrifuge.

Allow rotating assembly to coast to a full stop.

2. Disconnect feed pipe from feed tube flange.

3. Remove screws securing belt guard to case, and lift and remove guard.

WARNING! WHILE OPENING AND CLOSING THE CENTRIFUGE COVER,

PERSONNEL MUST ENSURE THAT ALL BODY LIMBS AND ANY OTHER

ITEMS ARE CLEAR OF THE COVER GAP. TWO OPERATORS MUST BE USED,

WITH BOTH HANDS ON THE COVER HANDLES AT ALL TIMES. DERRICK

RECOMMENDS HAVING A HOIST AVAILABLE IF ADDITIONAL ASSISTANCE

IS DESIRED DURING THE OPENING/CLOSING PROCEDURE.

4. Remove screws securing case cover to case, and open case cover as described at the

beginning of this section.

5. Loosen screws securing torque limiter clutch half to conveyor drive motor shaft (Figure 5-4),

slide coupling half toward motor until end of motor shaft is visible, and remove spider.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 166 167

Sem comentários

AOpen DE7200 Series Instruções de Operação Página 73